Techniks Capto Compatible SlimFIT holders

Techniks Capto Compatible* SlimFIT feature an internal drawbar that provides greater clamping force on the collet then ER collets. This design permits a narrow nose diameter of only .55".

Use with SlimFIT 6 collets and extensions
for shank sizes from 3/32" up to 1/4".

*Compatible with the Capto tool system. Techniks products are not affiliated with or endorsed by Sandvik AB.

Features

  • Maximum T.I.R. only 0.0001"
  • Balanced to 25,000 RPMs at G2.5
  • Nose diameter only 0.55"

Techniks Certified for accuracy and balance

Techniks Certified Tooling means the critical features of each holder has been individually lab tested, measured and inspected for quality. Depending on the holder this can include: balance, dimensional accuracy, collet pocket runout (T.I.R.), bore I.D. and taper accuracy. Techniks Certified guarantees your holder will meet or beat our published specifications.

         

Also see our Capto Compatible: ER Chucks, End Mill Holders, Face Mill Arbors, ShrinkFIT Holders, and Turning Tools.

C4, C6, SlimFIT Holders

Part No.
Description
L
l1
d1
Size Range
141.648.06.075 Capto C4 x SBL 6–75mm
94mm
75mm
.55"
3–6mm
143.648.06.080 Capto C6 x SBL6 -80mm
118mm
80mm
.55"
3–6mm